Moulded commutators SUKaT Ø 60–350 mm, peripheral velocity of 60-80 m/sec, heat classes F and H, with permanency of form. May be used f.e. for engines of material trucks operatting under high mechanical and thermal stress ( fork-lift trucks ).
Concept of the solution
The internal construction differs from common constructions of moulded commutators. The anchorage of segments in the cyrrying sleeve with the use of dovetails with definitively given outer form and position of the segment in resulting in the construction featuring a high radial stiffness and ensuring considerable mechanical stability of the commutator segment ring. A relatively thin layer of pressing material enables a very good heat transfer between the segment ring and the commutator sleeve.
Advantages of the solution
High permanency of form at extremely high peripheral velocity and elevated temperature
Big cross section for cooling ducts in the commutator sleeve independent of the commutator length
High efficiency of motor cooling
High dimensional and form accuracy
Insulation class F, on special reguest class H
Operating data
Segment copper – ECu or CuAg 0,03 % or 0,1 % or as requested
Segment insulation – built-up mica, remica or as requested
Commutator sleeve – steel, either with air events of different execution or without the air vents
Diameter range - 60–350 mm
Axial length of the commutator segment - 25 – 250 mm
The commutator is available with or without lugs, with cut-through grooves for conductors tinned or without tinning, or without the grooves.
Commutators may be produced in large and smaller quantities or even as piece goods at low costs of manufacture preparation and short time of delivery.
